Automatic Shift Knobs

[james32thedge]

From what I remember, it's just the one piece (carbon surround with the boot portion). The hardest part was getting the boot over the new know, had to cut and stretch a little.

Thx so I gather after removing the auto trim and boot part the manual boot just snaps in after putting the boot over the shifter, thx again

Sponsored

 

[bee bop]

Thx so I gather after removing the auto trim and boot part the manual boot just snaps in after putting the boot over the shifter, thx again

Yes you completely remove the trim and boot and replace it with the manual cover.

 

[roket]

i forgot to share it here, but i got the Billetworkz titanium shift knob and the manual shift boot and installed them, also anodizing the shift knob. here is the final result

and here was my anodizing setup

power bank going into a USB-C PD board set to 20V, positive on the bolt the shift knob was threaded onto via aluminum wire, negative on the aluminum sheet that goes into a baking soda and distilled water solution. i used a rotary tool with an abrasive buffing end to remove the shift knob's protective coating first, because otherwise it was just turning an ugly yellow-green

 

[james32thedge]

Yes you completely remove the trim and boot and replace it with the manual cover.

Thx

 

[DarkkMatter]

For an Automatic Shift Knob replacement, I think a Black Horse Head with Red Eyes would look cool.
Probably can 3D print one out of the right material.
On a manual though, having to shift often, that wouldn't be easy on the hands.

Sponsored