Not yet. Reach out to Steeda & BMR for information.
Will do, thanks!
It should be the same chassis, I bought mine at AmericanMuscle. Call them. They were only 119.00.
Incorrect. Steeda offers jacking rails for the ragtop S650. Same as the S550:
Did you happen to notice the date of my post? People resurrect old threads all the time.
Yes, but I sent them back, personally I was not satisfied with the fit. This was back in the fall of 2024. At that time even Steeda acknowledged that they were unsure if they were going to fit the 650 model. To me they were too flimsy and you would need to remove the fasteners that held the protection board along the rails. Even if you did that, the amount of deflection was in my opinion not acceptable. Initially Steeda wanted to review what my concerns were but then i never heard from them. Then again when I made similar comments to this on another thread they asked me to contact them (which I did) but again, never responded. Honestly I was not impressed.
Hey, thanks for the reply. I installed mine yesterday. They must have made significant changes because they are anything but "flimsy"!! Very, VERY sturdy. My issue is that once installed they are not exactly parallel to the ground. The rails are both at a slight angle when compared to the ground. Called Steeda and discussed this with them. Was told that that fit was perfectly good. They look really nice but I do think it's a little weird that they are not at a level angle to the the ground.
They are the same product, and yes, our team has the expertise to assist with your question - we did adjust longer bolts in the front only due to a change Ford made on the S650 k-member tab.
I spoke with you several times & also included our manufacturing team - if it wasn't you, then it was Tom we spoke with to review the concern.
