No Drill License Plate Holder

[dfwford]

Bumping this thread to share that I ordered Craig's Custom Mustang Bracket.

https://ccmustangbrackets.com/products/2024-mustang

I also ordered these silicone frames, which fits seemlessly on the bracket.

https://www.amazon.com/your-orders/...pmentId=Xt1ZQsXfs&packageId=1&asin=B0BRKTKJ4S

They were both very easy to install (only took minutes). As far as the adhesive, it was in the upper 70s when I drove it 1 hour after installation and it held just fine at higher speeds, although the instructions recommend waiting 48 hours if it's too hot (above 85*F) / too cold (below 60*F).

Sponsored

 

[ToyPonyForTony]

Bumping this thread to share that I ordered Craig's Custom Mustang Bracket.

https://ccmustangbrackets.com/products/2024-mustang

I also ordered these silicone frames, which fits seemlessly on the bracket.

https://www.amazon.com/your-orders/...pmentId=Xt1ZQsXfs&packageId=1&asin=B0BRKTKJ4S

They were both very easy to install (only took minutes). As far as the adhesive, it was in the upper 70s when I drove it 1 hour after installation and it held just fine at higher speeds, although the instructions recommend waiting 48 hours if it's too hot (above 85*F) / too cold (below 60*F).

Thats funny, that is my car. The plate holder works great. Easy to take off for cleaning, car shows etc. Craig is a nice guy, i contacted him when i picked up my car and he asked that i stop by so he could get measurements. Highly recommend this product.

 

[friscoaggie]

Think it only comes with DH handling package.

I finally pried off the toe hook cover on my non-hp DH and the threaded mount is there, I will just need to buy the toe hook and/or toe hook mounting bracket.

Sponsored