WAL and Seat Belt Display Help

[Cobrakit]

So first, I tried to set WAL function in APIM As Built by changing 7D0-09-05-xxxx-*xxxx from 3 to B ? WAL didn't turn on. BCM 726-91-01 already had 1's.

Also, tried to get rid of Seat Belt display on dash in IPC changing 720-13-01 and 720-13-02 to all Zeros. Display changed by not showing seats, but overall Display still there. Not sure getting rid of Display is an option.

Sponsored

 

[smurfslayer]

Hmm... The seat belt splash removal worked for me and ... I think 2 others. Another poster suggested using another value besides zero but I haven’t confirmed that.

You need to ignition cycle at least once, did you do that?
weird.

 

[Cobrakit]

So is easy mode, the Splash Display only had options with numbers. Mine was option 2, so i changed to 1. Display no longer shoes seats and no chimes. i had already changed IPC 720-13-01/02 to zeros.

Plus WAL not working changing APIM by enabling Easy Mose WAL. Changed APIM As Built 7D0-09-05 already.

 

[smurfslayer]

I did not use easy mode for the seat belt splash. Have not bothered with WAL because of all the drama surrounding it.

 

[Cobrakit]

I did not use easy mode for the seat belt splash.

So what did you use fir seat belt splask?

IPC As Built 720-13-01/02 and then what?

 

[smurfslayer]

I used the “old school” way; go to the section in the as-built ; update, check it, write it. cycle ignition. If you look at the update for splash screen I put in the thread, linking to the original, the 2 fields are splash and seat belt minder. I already suppressed the minder ; the flashing icon on the dash - via the youtube method for the F series, the manual is wrong. So I did the splash screen to zeroes. Again, another poster suggested a non-zero value, I have not yet tested that.

Sponsored